Wonder Fount 2 in 1 Fount Solution

This fountain solution is for Alcohol damping presses and eliminates the need to mix the fountain solution and alcohol together. No pH and conductivity control are necessary.

When using on presses with automatic dosing of alcohol and fountain solution switch off the fountain doser, then remove the alcohol from the dosing unit and replace it with Wonder Fount 2 in 1 fountain solution. Set the alcohol doser to read 10% and recommence running. The fountain solution will then consist of 10% alcohol and 2% fountain solution. The pH reading will be between 5.0 -5.2 and the conductivity reading will be approx 800ms (depending on the water supply). The fount can be decreased as low as 7% if no scumming is apparent OR increased to 15% for excessively hot and humid conditions or jobs with exceptionally large image areas. The pH will be constant and the conductivity will be approx 1000ms but it is of no consequence. The surface tension of the fount solution will be 40 dynes the same as if I.P.A. were in use. For hand mixing where no fount doser is available place 3 litres of Wonder Fount 2 in 1 fount into a 25 litre container and fill up with water. Then add the diluted fount to the press

Eliminates the need for a separate fountain doser on alcohol damping presses. Less chemicals to mix on hand fed presses. No other fountain solution required. Just add water

• Add one solution instead of conventional two pack IPA and Fount = less user error and easier control
• Less flammable (Higher flash point of 39 Degrees Celius) = safer as no separate IPA in the pressroom
• Greater wetting properties therefore less dampening solution to press = more efficient
• Less Water useage = quicker ink drying
• Less Ink useage = save up to 10% on ink usage
• Sharper Dot and Lower Dot gains = cleaner, sharper and brighter image
• Lower VOC 's = safer and non carcinogenic

• Higher flash point than I.P.A
• Water settings down Approximately 25%
• Ink settings down 10%
• Faster colour balance on Change over of jobs.
• Clean back cylinders.

• Safer to use.
• Reduced ink costs.
• Faster turn around
• Less waste
• No operator mixing error
• Brighter colours
• Less chemical mixing

• FOGRA approved
• 20% Less water
• Faster ink water balance
• More control of colour
• Higher flash point
• Lower VOC
• Safer to use than IPA
• Premixed balanced equation